Quantum ACL 4/52, Руководство оператора

Страница: 39 / 68

Chapter 2 Operating Procedures
Operating Procedures
ACL 4/52 Operator’s Guide 23
Removing Power from
the Library
2
To remove power from the library:
1 Press the control panel STOP button.
2 Press the control panel STANDBY button and verify that System
Off-line
is displayed in the SDA.
3 At the rear panel, set the AC power switch to the O (off) position.
Inserting Tape
Cartridges
2
To insert a tape cartridge:
Caution: DO NOT USE
CompacTape I
,
CompacTape II

or
CompacTape
IIIXT
tape cartridges in this library.
Caution: Examine all cartridges before loading them into the library
or tape drive. Look for label stock or other foreign material
that may be clinging to the cartridges.
1 Press the load port
OPEN
button and verify the indicator begins
blinking. (It may require several seconds for the load port door to
automatically open.)
Warning:
Mechanical hazards could be exposed when the load port is
partially open or closed. Do not attempt to insert hands or
fingers into the load port opening at any time.
2 With the load port door open, place the tape cartridge(s) in any
available bin. (The proper orientation for tape cartridge insertion is
shown in figure 12 on page 24).
3 Press the load port
CLOSE
button.
Caution: The load port door is locked in the open position. You must
press the
CLOSE button before attempting to close the load
port door.
4 When the CLOSE indicator is steadily lit, push the load port door
closed. (The library will lock the door.)