Qualstar XLS-810160, Руководство по установке

Страница: 64 / 208

5.6 Lowering the Leveling Feet
5-10 501801 Rev. 07-01-19
2. Using a 3/4-inch open-end wrench, turn one of the jam nuts to loosen the leveling
foot. See
Figure 5-12 .
3. Using the same wrench, extend the leveling foot until it touches the floor. Then,
turn the nut two more complete turns. See
Figure 5-13 .
4. Repeat steps 2 and 3 to extend the three other leveling feet.
5. Check the alignment by placing a precision level on top of the LRM and MEM.
Figure 5-12 Loosening a leveling foot
Figure 5-13 Extending a leveling foot
Important: Depending on the floor conditions, you may need to
adjust the leveling feet on the LRM or the MEM up or
down. Keep checking the alignment until both the LRM
and the MEM are at an even level.
Turn jam nut to
loosen leveling foot
1. Lower the foot to the floor.
2. Turn the nut 2 more turns.