Qualstar XLS-810160, Руководство по установке

Страница: 54 / 208

4.1 Extending the Leveling Feet
4-2 501801 Rev. 07-01-19
3. Using the same wrench, extend the leveling foot until it touches the floor. Then,
turn the nut two more complete turns. See
Figure 4-2 .
4. Repeat steps 2 and 3 to extend the three other leveling feet.
5. Check the alignment by placing a precision level on top of the LRM.
6. If you are installing a MEM, refer to Chapter 5, “Installing a MEM.”
or
7. If you are not installing a MEM, turn all four jam nuts clockwise until they push
up against the frame. See
Figure 4-3 .
Figure 4-2 Extending a leveling foot
Important: Depending on the floor conditions, you may need to
adjust one or more of the leveling feet up or down. Keep
checking the alignment until the LRM is at an even
level.
Figure 4-3 Tightening a leveling foot
1. Lower the foot to the floor.
2. Turn the nut 2 more turns.
Turn jam nut until
it pushes against
the frame