PT CPC5565, Руководство пользователя, Страница: 28 / 118

Chapter 2: Introduction
28
provide isolation from the CPC5565. See the topic “PTMC Interface (Build Option)” on page 28 for
more information about the site.
• Two channels to the host CPU via the 82571 dual NIC (ENET A and ENET B BIOS setup options).
The on-board devices are grouped in pairs to support link aggregation to the switch to allow
greater throughput and redundancy during normal operation.
The topic “Ethernet” on page 115 , contains links to the product brief for the Broadcom
BCM5389 Ethernet controllers used on board the CPC5565. Connector locations and pinouts
are documented in
Chapter 5, “Connectors,” on page 79 .
SATA Interface
The CPC5565 includes an integrated Serial ATA (SATA) controller that routes five independent
SATA interfaces, each of which is SATA 1.0 compliant:
• SATA drive mounted to the on-board SATA connector (build option)
• Four SATA ports routed to RPIO connector J5
The CPC5565's SATA controller resides in the Intel 3100 chipset. The topic “Chipset” on
page 115 provides a link to the data sheet for this device. RPIO connector J5 location and
pinout are documented in the topic “J5 (Rear-Panel User I/O Connector)” on page 90 .
Rear Transition Module (Optional)
The RTM4811, an advanced rear transition module, offers support for a SATA 2.5-in. hard drive
disk, an analog VGA video interface, and USB. The CPC5565 can boot from SATA storage on
this RTM or through a SATA connector on the RTM faceplate.
By using the RTM4811, the CPC5565 can be chained to a CPC5910 storage expansion
module that contains two SATA 3.5-in. hard drive disks to make a local storage array with up to
3 TB of directly attached storage. See the topic
“User Documentation” on page 117 for links to
more information about the RTM4811 and CPC5910.
PTMC Interface (Build Option)
The CPC5565 is optionally also a PMC carrier card that supports the following specifications:
• Complies with PICMG 2.15 R1.0 configuration 7 (PT7CC)
• Dual channel Ethernet links (MDI) compatible with PICMG 2.15 ECN 2.15-1.0-001 (Ethernet MDI
Links on PTMC, configurations 5 and 6)
• Complies with IEEE1386.1 PCI Mezzanine Card (PMC)
• Complies with VITA 39: PCI-X for PMC (133 MHz)
• Complies with PCI-E v1.0 and 1.0a (PCI-Express)
• Support 3.3V VIO Cards Only
The PCI Telecom Mezzanine Card (PTMC) interface is compatible with the PICMG 2.15
PT7CC Specification . The PTMC provides a way to add modules such as IPSec accelerators
and network processors to increase baseboard functionality.