Pict. 10 - How to tune the nozzle height live during the test print. Note: -0.640 mm is only for
illustration. Your setting will be different!
Observe the line which is being extruded on the print surface. A new menu will automatically
show up where you can tune the nozzle height in real time by turning the knob. The aim is to
adjust the nozzle height until the extruded plastic sticks nicely to the bed and you can see
that it is being slightly squished. The value should not exceed -2.000 mm.
If you have to
adjust it more (e.g. -2.500), move the SuperPINDA probe slightly higher. Please refer
to
in case the SuperPINDA probe needs to be re-aligned.
Loosen the M3 screw on the probe holder to make adjustments. Gently push or pull the
sensor to adjust the height and tighten the M3 screw again. Then re-run Calibrate Z followed
by the First layer calibration again.
27
