9
end
connectors:
(See Figure 1)
Gate Opening
Gate Strength
A
Steel Carabiner
18 mm (11/16 in)
16 kN (3,600 lbf)
B
Steel Snap Hook
19 mm (3/4 in)
16 kN (3,600 lbf)
C
Steel Snap Hook
19 mm (3/4 in)
16 kN (3,600 lbf)
D
Steel Snap Hook
19 mm (3/4 in)
1 kN (225 lbf)
E
Aluminum Rebar Hook
52 mm (2 in)
16 kN (3,600 lbf)
F
Steel Rebar Hook
60 mm (2-3/8 in)
16 kN (3,600 lbf)
7.3 laBeling:
Figure 8 illustrates Rebel SRL labeling. All labels must be present and fully legible.
1
Visually inspect unit. Read instructions.
2
Inspect locking action of SRL. One user maximum.
3
Correct way of connecting SRL to harness.
4
May be connected to an anchorage point above or level with the dorsal D-Ring. 140 kg (310 lbs) maximum.
Avoid sharp edges.
5
Temperature usage range -40°C + 60°C.
6
Maximum capacity 140 kg.
7
Always allow the lifeline to recoil back into the SRL under control.
8
Do not repair.
9
Store indoors.
10
Do not place the SRL housing on an edge during use.
11
Do not remove label.
table 2 – inspection checklist
component:
inspection:
Pass
Fail
SRL
(Figure 9)
Inspect for loose fasteners and bent or damaged parts.
Inspect the Housing (A) for distortion, cracks, or other damage.
Inspect the Swivel (B) and Swivel Eye (C) and Carabiner (D) for distortion,
cracks, or other damage. The Swivel should be attached securely to the SRL,
but should pivot freely. The Swivel Eye or Integral Connector should rotate
freely in the Swivel.
The Web Lifeline (E) should pull out and retract fully without hesitation or
creating a slack line condition.
Ensure the SRL locks up when the Lifeline is jerked sharply. Lockup should be
positive with no slipping.
All labels must be present and fully legible (see Figure 8).
Inspect the entire SRL for signs of corrosion.
Web Lifeline
(Figure 10)
Inspect the web lifeline for concentrated wear, frayed strands, broken yarn,
burns, cuts, and abrasions. The lifeline must be free of knots throughout its
length. Inspect for excessive soiling, paint build-up, and rust staining. Inspect
for chemical or heat damage indicated by brown, discolored, or brittle areas.
Inspect for ultraviolet damage indicated by discoloration and the presence of
splinters and slivers on the lifeline surface.
Energy Absorber
(Figure 11)
Inspect the Energy Absorber to determine if it has been activated. There
should be no evidence of elongation and the cover should be secure and free
of tears or other damage.
Содержание Rebel 3100423
Страница 3: ...8 3 3m 11 ft 6 0m 20 ft 3 ...
