Promeba PB-460 Series, Руководство пользователя

Страница: 21 / 32

USER GUIDE // STRETCHER SUPPORT SERIES PB460 AND PB455
Review 2022/02
21
03
OPERATION
Function Button Description
ASCENT DESCENT
1
The two motors will retract synchronously and the
stretcher support will rise. Keep the button pressed un-
til you get the desired position.
2
The two motors will extend synchronously and the
stretcher support will lower. Keep the button pressed
until you get the desired position.
TRENDELENBUR
G
ANTI-
TRENDELENBUR
G
3
Motor 1 will retract and motor 2 will extend, to obtain
the Anti-Trendelenburg position. Keep the button pres-
sed until you get the desired position.
4
Motor 1 will extend and motor 2 will retract, to obtain
the Trendelenburg position. Keep the button pressed
until you get the desired position.
LO
ADING POSITION REST POSITION
5
Press the button for 1 second, both motors will simul-
taneously move to the preset load position. The buzzer
will beep when reaching the position.
6
Press the button for 1 second, both motors will move
simultaneously to the preset 0 or rest position, and the
buzzer will beep when reaching it. Then the two motors
will continue to open simultaneously until the stretcher
support descends to its minimum position. The buzzer
will beep again when this position is reached.
RESE
T
1+3
By pressing buttons 1+3 for 3 seconds, the bed will go
up to its maximum position and will go down to its mi-
nimum position. Upon completion of the operation,
the remote’s LED will flash 3 times and the buzzer will
beep.
M
AXIMUM
EX
TENSION
2+4
By pressing buttons 2+4 for 3 seconds all actuators will
extend to their maximum stroke. Upon completion of
the operation, the remote’s LED will flash 3 times and
the buzzer will beep.
ST
OP
-
To stop the movement during the load position and
rest position operations, press any button on the hand
control or or the emergency stop button on the stret-
cher support and all the actuators will stop.
5
3
1
6
4
2
FIGURE 5
LOAD POSITION: The platform is extracted and tilted by lowering the rear end of the stretcher support to
be able to carry out the loading or unloading operation of the stretcher correctly.
ZERO POSITION: The stretcher support moves until it is completely horizontal.
RESET: It will be necessary to carry out a RESET in case any of the actuators has to be changed or if there is
a fault in the electronics.
The table below shows the different commands of the hand control (see figure 5).