Promax HD Ranger +, Руководство пользователя

Страница: 126 / 224

9-118 December 2014
9.4 RF Connector
►
DiSEqC commands :
The RF connector allows controlling an antenna using DiSEqC commands. DiSEqC
(Digital Satellite Equipment Control) is a communication protocol between the
satellite receiver and the installation accessories of satellite (switches, LNBs,
etc.) proposed by Eutelsat, in order to standardize the diversity of switching
protocols (13 to 18 V, 22 kHz) and meet the needs of the installations for the
reception of digital TV.
Connect the RF cable ( see Figure 6 ) to the RF connector for the input
signal of the equipment.
Press the Spectrum key to access the spectrum analyser mode.
Press the Settings key and select the satellite band.
From the Settings menu, select the polarization (horizontal/vertical)
and the satellite band (high/low).
If necessary, enable the Supply output and select the supply voltage
for the LNB.
Select the option DiSEqC mode .
Two new functions appear on the softkeys: Command and
Software . DiSEqC programs appear classified in categories or
folders.
Select the command or program and press the joystick to send it to
the antenna. These commands or programs allow the user to control
an antenna (for more information about DiSEqC commands and
programs see
Annex 3 ).
►
SatCR commands :
By means of function SatCR it is possible to control the devices of a TV satellite
installation that are compatible with the SatCR (Satellite Channel Router)
technology, which allows to concentrate downlink frequencies (slots) by an only
cable. By this way each user using a slot can tune and decode any signal present
in the satellite.
Connect the RF cable ( see Figure 6 ) to the RF connector for the input
signal of the equipment.