Printware iJet Press, Руководство оператора

Страница: 55 / 88

SECTION 4
MAINTENANCE
49
Removing the Wiper Motor Assembly
Remove the Service Station; if not already removed.
[A] Disconnect the Wiper Module cable from the Service
Station Printed Circuit Board.
[B] Lift out the Wiper Motor Assembly.
[C] Loosen the two small screws retaining the Wiper
Roller Latches just enough to release the (2) Latches.
DO NOT remove the screws!
[D] Remove the Wiper Roller.
Install in reverse order. Use a foam swab to lightly
lubricate the Wiper Gears (3) with synthetic PTFE grease
(Super Lube 21030 or equivalent).
NOTE: Make sure
Wiper Roller Latch Screws are fully tightened and the
Latches are fully closed before installing Service Station
into the Printer.
Cleaning the Wiper Motor Assembly
Remove as specified in " Removing Wiper Motor Assembly "
above.
1. Pour distilled water into a flat-bottom container to
about 17mm deep.
2. Carefully immerse the Wiper Assembly, Motor side
up, into the water.
WARNING!
DO NOT IMMERSE MOTOR OR GET
MOTOR WET TO AVOID DAMAGE.
3. If vents are showing, carefully add more water until
they are covered.
Allow the Wiper Assembly to soak
for 10 minutes.
4. Carefully remove the Wiper Assembly. Inspect the
vents and remove any debris with tweezers. Pat dry
with an absorbent towel.