Printware iJet Press, Руководство оператора

Страница: 17 / 88

SECTION 2
INSTALLING THE PRINTER
11
3
5
6
7
8 9
3. Attach the Rear Media Support Guide using the
knob [3] provided.
The two outer holes in the guide fit over the
socket head screws; as shown.
4. Install the desired Media Support Wedge using the
mounting hardware [4]; as described below.
Choose the appropriate Media Support Wedge for your
application:
Wide Media Support Wedge [5]
– For media that is 8 inches wide or greater.
Narrow Media Support Wedge [6]
– For media that is less than 8 inches wide.
The Anchor Plate [7] fits into the slot, from the underside
of the Rear Media Support Guide. Position the Media
Support Wedge so the upper and lower holes fit onto the
two tabs from the Anchor Plate.
The washer [8] goes between the Thumb Screw [9] and
the Media Support Wedge. The Thumb Screw is inserted
down through the washer, then through the center hole in
the Media Support Wedge and into the threaded hole in
the Anchor Plate. Tighten the thumb screw to secure the
Media Support Wedge onto the Rear Media Support
Guide.