Printware iJet Press, Руководство оператора

Страница: 35 / 88

SECTION 3
OPERATING THE PRINTER
29
Printer Status Light Indicator Chart (continued) (see legend)
Valid with Firmware 110928_u or higher installed.
ON/OFF
PAPER
RESUME
PAUSE
CANCEL
Printer Status
corresponding Toolbox message
Additional Details, Possible Solution or Action

ON

ON

OFF
Paper Jam Detected
Toolbox =
PAPERPATH_PAPERJAM
Any of the following conditions could exist:
Paperpath: Entry : Yes Exit: Yes
or
Paperpath: Entry : No Exit: Yes
or
Paperpath: Entry : Yes Exit: No
Printer has detected that one of the media (PaperPath) sensors is
blocked (interrupted).
Carefully remove jam and or clean PaperPath sensors.
Make sure the clamshell is closed and securely latched.
If the PaperPath sensors are clear; the toolbox “PaperPath” line
should change to Paperpath: Entry: No Exit: No
No = not blocked (not interrupted), Yes = blocked (interrupted)
After you fix the condition you can;
-
Press the RESUME button on the printer or press the “Clear Error”
button in the Toolbox; to continue printing
- Press the CANCEL button to cancel the job, and then manually
clear job from the computer’s print queue.

ON

/

fast

/

fast
Printhead Missing
Toolbox =
PRINTHEAD_MISSING
Replace missing Printhead.
Printhead Not Primed
Toolbox = PRINTHEAD_UNPRIMED
Follow Printhead Priming procedures.
If you continue to have trouble; check for kinked or pinched ink color
tubes or call for Service.
Clamshell Open
Toolbox
–
DOOR_OPEN_FRONT
Make sure the clamshell is fully closed and latched.
If problem persists; call for Service and have them check the
clamshell switch.
Note: This switch is not present on printer S/N 100027598 or lower.
Other Errors
– See Toolbox
Open Toolbox to view error.
Fix condition then press
“Clear Error” button in the Toolbox.
Please see the “
Toolbox System Status Messages
” section for more details on Toolbox messages.
Simultaneous Fast Flash
(3/sec)