Printed in U.S.A. 1/06 © 2006
2
625-505revI-EN
Steamer
625-MCD & MFY
Safety Information
Indicates information important to the proper operation of the
unit. Failure to observe may result in damage to the
equipment and/or severe bodily injury or death.
Indicates information important to the operation of the unit. Failure
to observe may result in damage to the equipment.
WARNING
CAUTION
Important
Prince Castle reserves the right to change specifications and
product design without notice. Such revisions do not entitle the
buyer to corresponding changes, improvements, additions or
replacements for previously purchased equipment.
Installation
Remove the unit from the carton and inspect for signs of damage. If there
is damage to the unit:
•
notify the carrier within 24 hours of delivery
•
save carton and packaging materials for inspection purposes
•
contact your local dealer, or if purchased directly, the Prince Castle
Sales Department at 800-722-7853 or 1-630-462-8800 to arrange for a
replacement unit.
WATER CONNECTION REQUIREMENTS
If this is a new installation, accessory - 625-104 Regulatory Assembly Kit
is required for the 625-MCD. The 625-MFY comes with the 625-253S
Regulator Assembly. Always use area codes for determination.
NOTE: When installing this unit, the ambient temperature at the mounting
site should not exceed 37.8°C (100°F).
All electrical connections must be in accordance with local electrical codes
and any other applicable codes.
Plug the unit into an applicable electrical receptacle. Connect the water
line to the back of the unit.
Water connection must provide maximum water pressure of 20 – 30 psi
(138 – 207 kPa).
CAUTION
CAUTION
Operation
A. Turn unit power On/Off switch to ON position. The display
flashes all segments for 3 seconds. Then display will show
PRINCE CASTLE
for seven seconds.
B. After ten seconds the display will show
PRE-HEAT
.
NOTE: The next-to-left most decimal point appears indicating
power is applied to the platen. Platen will heat to the setpoint
temperature.
1
Place the spatula fully into the unit and press the START button. A
beep will sound and the display will start to count down the steam
cycle. (The countdown will round down to the nearest second, e.g.
11.5 seconds will appear as 11 seconds in the display.)
3
2
A. When the unit reaches the setpoint temperature, display will
show the product name assigned to button 1.
B. If 1 is the desired product to be steamed, pull out the spatula
and place the product onto the spatula, cut side down.
Or press product buttons 2, 3 or 4, then place product on the
spatula, cut side down.
When steam cycle is complete, the unit will sound a tone and the
display will flash
REMOVE
.
Pull out the spatula and remove the finished product.
4
