PRIMERGY BX600 S3, Руководство по оборудованию

Страница: 11 / 143

11
PRIMERGY BX600 Management Blade Hardware Guide
1.2 Component Names and Functions
This section explains the names and functions of the various parts of this product.
When the Management Blade is restarted or the operation mode is changed, the error LED will light up
or blink temporarily but if it turns off after a short while, there is no error.
1 3
4
2
5
6
7
8 9
10BASE-T/100BASE-TX
(close up)
1
Serial port (9 pin)
The RS-232C cross cable (one cable is attached with the
chassis) connects the Management Blade to the
management terminal.
2
Lithium battery
3
Chassis connection connector
This is a connector used for connecting to the chassis.
4
Jumper pins
5
10BASE-T/100BASE-TX connector
An unshielded twisted pair (UTP) cable is plugged in.
6
LAN active LED
Blinking (Amber): transmitting data
*: Blinks uniformly when NIC diagnostic function of
the Management Blade is used.
7
LAN link LED
LED ON (Green): link established
8
Management Blade master LED
This lights up when the Management Blade is operating
in master mode.
9
Management Blade error LED
This lights or blinks when a Management Blade error
occurs as follows.
If this LED lights or blinks, contact an office listed in
the "Contact Information" of "Start Guide".
LED status Management Blade status
ON (Green) Operating in master mode
OFF Operating in slave mode
LED status Management Blade status
ON (Amber) A Management Blade error has
occurred (non redundant
Management Blade
configuration).
Blinking (Amber) A Management Blade error has
occurred (redundant
Management Blade
configuration).
OFF No error detected.