PRIMERGY BladeFrame BF200, Инструкция по первоначальной настройке

Страница: 30 / 115

Initial Setup Guide cBlade ES
2-10 Release 5.0
• When you set up the floorstand model with hot-plug power
supply units, you should ensure that the supplied anti-tilt bracket
is correctly fitted to prevent tilting.
• Route the cables in such a way that they do not form a potential
hazard (make sure no-one can trip over them) and that they
cannot be damaged. Refer to the relevant notes in the operating
manual when connecting the device.
• No data transmission cable should be connected or disconnected
during a thunderstorm (lightning hazard).
• Make sure that no objects (such as bracelets or paper clips) fall
into or liquids spill into the device (risk of electric shock or short
circuit).
• In emergencies (e.g. damaged casing, elements, or cables,
penetration of liquids or foreign matter), switch off the device
immediately, remove the power connector from the grounded
power socket, and contact your customer service center.
• Proper operation of the device (in accordance with IEC 60950/
EN 60950) is only ensured if the casing is completely assembled
and the rear covers for the installation openings have been put in
place (electric shock, cooling, fire protection, interference
suppression).
• Install only system expansions that satisfy the requirements and
rules governing safety and electromagnetic compatibility and
relating to telecommunications terminal equipment. If you
install other expansions, you may damage the system or violate
the safety regulations and regulations governing RFI
suppression. Information on which system expansions are
suitable can be obtained from the customer service center or
your sales outlet.
• The components (e.g. power supply) marked with a warning
label (e.g. lightning symbol) may only be opened, removed, or
exchanged by authorized, qualified personnel. The hot-plug
power supply units are exceptions to this rule.
• The warranty is invalidated if the device is damaged during the
installation or replacement of system expansions.