Prima MIG 210 SYNERGIC, Руководство по эксплуатации

Страница: 23 / 27

23
15.0 TECHNICAL DATA INFORMATION GUIDE
FIG. 16
FIG. 17
1
Serial Number of the Unit
2
Power source model
3
Kind of characteristic
4
Min. - Max rated No Load Voltage
5
Kind of welding
6
Symbol for the main supply and no. of pha-
ses
7
Rated value of the supply voltage
8
Code letter for degree of insulation
9
Protection degree
10
Power
11
Size of the necessary main fuse
12
Supply current
13
Welding supply and voltage
14
Power Factor
15
Control range (current / voltage)
16
Referring standard
16.0 WELDING HINTS AND MAINTENANCE
√
Always weld clean, dry and well prepared material.
√
Hold gun at a 45° angle to the workpiece with nozzle about 6mm from the surface.
√
Move the gun smoothly and steadily as you weld.
√
Avoid welding in very drafty areas. A weak pitted and porous weld will result due to air blowing away the protective welding gas.
√
Keep wire and wire liner clean. Do not use rusty wire.
√
Sharp bends or kinks on the welding cable should be avoided.
√
Always try to avoid getting particles of metal inside the machine since they could cause short circuits.
√
If available, use compressed air to periodically clean the hose liner when changing wire spools
IMPORTANT: Disconnect from power source when carrying out this operation.
√
Using low pressure air (20-30 PSI-3/5 Bar), occasionally blow the dust from the inside of the welder. This keeps the machine running cooler. Note:
do not blow air over the printed circuit board and electronic components.
√
The wire feed roller will eventually wear during normal use. With the correct tension the pressure roller must feed the wire without slipping. If the
pressure roller and the wire feed roller make contact (when the wire is in place between them), the wire feed roller must be replaced.
√
Check all cables periodically. They must be in good condition and not cracked.