MULTI-VARIABLE MONITOR - MANUAL
29 | MVM – Manual | AntecControls.com
CONFIGURATION
Before Arriving On-Site
Before scanning the BACnet network, it is important to determine which devices are being used for the information that will be
displayed on the Main Screen.
Below is a chart that can be used to map out the necessary information required for the Main Screen.
MVM Object
BACnet Device
BACnet Point Name
BACnet Object Number
Status_Value
Status_Background
Room Mode_Override
Pressure Mode_Value
Alarm Reason_Value
Caution Reason_Value
Temperature_Value
Temperature_Units
Pressure_Value
Pressure_Units
Humidity_Value
Humidity_Units
ACH_Value
ACH_Units
NOTES:
•
Not all points listed above will be required. Refer to the Configuration Type (found in the Antec Controls submittal
schedule) being used to know which points will be required on the screen.
•
Gather this information before going to the site to streamline the process for performing the
Adding Data Points to the Device
•
If configuring an MVM for multi-room displays, then this table should be completed for each room.
