PREVOST H 2018 Series, Руководство оператора

Страница: 154 / 258

5-40 OTHER FEATURES
PA1628 H3-41, H3-45 Operator’s Manual
The safety belt acts as a safety device and it
prevents raising or lowering the lift when not
buckled.
5. LOWER PLATFORM: Press and hold DOWN button until platform stops at ground level and rollstop
opens completely.
6. BUCKLE SAFETY BELT.
7. BOARD PLATFORM: Position wheelchair in center of platform, facing outward and advise occupant
to lock wheelchair brakes. Power must be turned off on electric-powered wheelchairs.
NOTE: Standee must stand near the center of the platform, facing in the direction of travel (into
vehicle), and firmly grasp handrails. Do not stand on bridgeplate.
8. BUCKLE SAFETY BELT (to enable lift controller): Insert belt tongue into buckle and listen for audible
“click” then tug belt to confirm belt is securely fastened.
NOTE: The next two steps apply only to F9TF/F9TH models that stop upward platform
movement at an intermediate level. Other models continue at step 11.
9. PARTIALLY RAISE PLATFORM: Press and hold UP button until platform stops at intermediate height.
10. OPEN SLIDING DOOR: Fully open vehicle sliding door located above lift. The lift operator, or
attendant should do this.
11. RAISE PLATFORM: Press and hold UP button until platform stops at floor height and bridgeplate
lowers onto vehicle floor.
WARNING
Verify that rear edge of bridgeplate lies flat
on floor along its entire edge and does not
create a tripping hazard.
12. EXIT PLATFORM: Advise passenger to carefully enter vehicle.
13. BUCKLE SAFETY BELT.
14. LOWER HANDRAILS: Press release button at base of handrail and lift the left handrail upward out of
its socket. Lower handrail to platform. Repeat for right handrail.
15. STOW PLATFORM: Press and hold STOW/IN button. Close sliding door at intermediate height. Press
and hold STOW/IN button until platform reaches STOW height and then fully retracts into vehicle.
NOTE: Do not use DOWN button to lower platform partway prior to stowing, and then complete
the stowing process by using IN button. This method may not properly stow platform.
16. CLOSE DOOR. Close the lift compartment door.
Normal Lift Operation – To Exit Vehicle
1. ACTIVATE INTERLOCK: Make sure parking brake is set and transmission is in neutral.
2. DEPLOY PLATFORM: Press and hold DEPLOY/OUT button until platform is fully deployed.
3. RAISE HANDRAILS: Lift right handrail to vertical and push firmly down into its socket. Repeat for
left handrail. Verify that both handrails are latched in place by attempting to pull upward on them.
4. BUCKLE SAFETY BELT (to enable lift controller): Insert belt tongue into buckle and listen for audible
“click” then tug belt to confirm belt is securely fastened.