Powermatic 60B, Инструкция по эксплуатации и перечень запасных частей

Страница: 15 / 44

15
6. Tighten the gib screws (A, Fig. 16) then back
off approximately 1/4 turn or until the table
moves freely, and reset the lock nuts on the
gib screws.
If table will not line up:
Remove gib screws and table locking handle and
remove gib. Check gib to see that set screws do
not go all the way through the gib or dimple the
opposite side. If either of these conditions exist,
replace with a new gib.
Also, check to be sure the ways are clean and
free of pitch and sawdust. Lubricate gib and way
with a good grade of non-hardening grease.
Replace the gib making certain that the punch
mark lines up with locking screw holes. Replace
gib screws. Repeat steps 3 through 6.
ADJUSTING DEPTH OF CUT
Depth of cut is determined by the height of the
infeed table relative to the cutterhead. Setting the
infeed table is achieved with both a rapid adjust
and a fine adjust.
Rapid Adjust:
1.
Loosen the lock screw (A, Fig. 17) and the
locking handle (B, Fig. 17).
2.
Raise or lower the height adjustment handle
(C, Fig. 17) until the scale (D-Fig. 17) reads
approximately the correct depth of cut.
Fine Adjust:
3.
Turn the locking handle (B, Fig. 17) until it is
snug, then fine-tune the adjustment with the
height adjustment handle (C, Fig. 17) by
rotating it until the scale reads exact.
(Clockwise raises the table, counterclockwise
lowers the table.) A full rotation of the fine
adjustment handle equals 1/16" travel of the
infeed table.
4.
When set, retighten lock screw (A, Fig. 17).
Periodically check the accuracy of the depth of
cut scale (D, Fig. 17) by raising the infeed table
until it is flush with the peak of the cutterhead arc
(using a straight edge across table and
cutterhead). The scale should read zero depth. If
it does not, readust the pointer above the scale.