Powermatic 60B, Инструкция по эксплуатации и перечень запасных частей

Страница: 19 / 44

19
Tilt the fence until it is flush with the
protractor.
5.
Rotate the screw (F, Fig. 23) to the proper
height.
6. Tighten hex nut (F, Fig. 23) and locking
handle (B, Fig. 23).
BASIC JOINTER OPERATION
NOTE: If you are inexperienced at jointing, use
scrap pieces of lumber to check settings and get
the feel of operations before attempting regular
work.
This section briefly discusses general rules as
well as some of the basic cuts using a jointer,
such as surfacing, edging, beveling, skewing,
rabbeting and taper cuts.
WARNING: Always use guard (except
for rabbeting) and keep hands away
from cutterhead.
JOINTING SHORT OR THIN WORK
When jointing short or thin pieces, use a push pad
or push block to eliminate all danger to the hands.
Two push pads are included with your jointer. You
can also make your own push block from scrap
material. Three types are illustrated in Fig. 24.
DIRECTION OF GRAIN
Avoid feeding work into the jointer against the
grain. This will result in chipped and splintered
edges (Fig. 25). Feed with the grain to obtain a
smooth surface (Fig. 26).
!