Powermatic 60B, Инструкция по эксплуатации и перечень запасных частей

Страница: 21 / 44

21
EDGE JOINTING
This is the most common operation for the jointer.
Set guide fence square with the table. Depth of
cut should be the minimum required to obtain a
straight edge. Do not make cuts deeper than 1/8"
in a single pass. Hold the best face of the piece
firmly against the fence throughout the feed. See
Fig. 28.
When edging stock wider than 3 inches, lap the
fingers over the top of the wood, extending them
back over the fence so that the fence casting will
act as a stop for the hands in the event of a
kickback.
BEVELING
When beveling never make cuts deeper than 1/16
inch. Make certain material being beveled is over
12 inches long, more than 1/4" thick and 1" wide.
CAUTION: Although the fence may be
tilted in or out for a bevel cut, It is
recommended for safety reasons that
the fence be tilted in toward the
operator, making a cradled cut.
Set fence to desired angle. For stock wider than
3", hold with the fingers close together near the
top of the stock, lapping over the board and
extending over the fence. When beveling material
less than 3" wide, use beveled push blocks.
SKEWING (Shear Cutting)
When edging or facing burl or birds-eye maple, it
is not unusual to deface or mar the surface being
finished. This is caused by the cutterhead blades
at times cutting against the grain. In order to
prevent the defacing or marring of this type wood,
it is necessary to skew, or angle finish, the
material being worked.
1. Release the fence locking handle (A, Fig.
29) and remove the two hex nuts and
washer (B, Fig. 29) holding the fence to the
fence support. Remove the fence assembly.
2.
Remove the key (C, Fig. 29) from the fence
support.
3. Replace the fence assembly at the desired
angle across the cutterhead. See Fig. 30.
Secure the fence to the support with the hex
nuts and washer (B, Fig. 29), then tighten
the fence locking handle (A, Fig. 29).
!