Powermatic 60B, Инструкция по эксплуатации и перечень запасных частей

Страница: 23 / 44

23
When rabbeting long pieces, follow the same
procedure for surfacing long pieces (page 20)
MAINTENANCE
WARNING: Disconnect machine from
power source before performing
maintenance.
The table and fence surfaces must be kept clean
and free of rust for best results. Some users
prefer a paste wax coating. Another option is
talcum powder applied with a blackboard eraser
rubbed in vigorously once a week; this will fill
casting pores and form a moisture barrier. This
method provides a table top that is slick and
allows rust rings to be easily wiped from the
surface. Important also is the fact that talcum
powder will not stain wood or mar finishes as wax
pickup does.
The fence assembly should slide easily over the
fence support. Keep fence support greased.
The bearings in the cutterhead are sealed and do
not require lubrication.
Gum and pitch which collect on the knives cause
excessive friction as the work continues, resulting
in overheating of the knives, less efficient cutting,
and consequent reduction in the life of the knives.
Use an oven cleaner or gum and pitch remover to
wipe this off the knives.
SHARPENING THE KNIVES
Knives should be kept sharp. This will contribute
to better stock finish, longer machine life, and
safer operation.
WARNING: Wear approved eye
protection when sharpening knives.
1.
Disconnect machine from power source.
2.
Remove cutter guard and place a shop scale
across the infeed and outfeed tables (Fig.
32).
3. Set tables to the exact height of the high
knife at the apex of its arc.
!
!