Powermatic 60B, Инструкция по эксплуатации и перечень запасных частей

Страница: 14 / 44

14
7. Rotate the cutterhead to the next slot by
turning the motor pulley, and repeat step #6,
only making the knives snug. Repeat for the
third knife. NOTE: Do not grab the
cutterhead itself to rotate it.
8. The tightening process should continue at
least two more times, each time tightening
the screws more on all three knives. On the
third time, they should all be firmly
tightened.
WARNING: Before starting jointer, make
sure all gib screws are firmly tightened.
A loose knife thrown from the cutter-
head can cause severe or fatal injury.
9. After replacing knives, the outfeed table
must be checked and, if necessary, adjusted
so that it is exactly level with the high point
of the knives.
LEVELING TABLES
Periodically check the parallelism of the infeed
and outfeed tables by placing a steel straight
edge (or carefully jointed wood) across both
tables. Non-parallelism caused by loose gibs may
be corrected by the following procedure:
1.
Loosen hex nuts on the gib screws (A, Fig.
16) with a 12mm wrench, then loosen the gib
screws with a 4mm hex wrench, and the
table lock handle (B, Fig. 16).
2. Remove lower gib screw (A*, Fig. 16) and
check screw hole to make sure that punch
mark in the gib is aligned with the screw
hole. If punch mark is not visible, or it does
not line up with screw hole, use a
screwdriver to lightly tap the gib back into
alignment.
3.
Replace the lower gib screw (A*, Fig. 16) but
do not tighten.
4.
Carefully tighten the table lock screw (B, Fig.
16). The table will begin to move toward the
straight edge.
5.
When aligned, reset the gib screws (A, Fig.
16) until tight. If table does not align with
straight edge, use the adjusting arm (C, Fig.
16) for the infeed table, or handwheel (D,
Fig. 16) for the outfeed table, until the table
is flush with the straight edge.
!