Powermatic 60B, Инструкция по эксплуатации и перечень запасных частей

Страница: 11 / 44

11
MOUNTING PULLEY GUARD
Place the pulley guard (A, Fig. 9) as shown and
secure with knob (B, Fig. 9).
MOUNTING DUST ADAPTOR
Place the dust adaptor over the opening in the
jointer stand, and secure with four 1/4-20 x 1/2
pan head screws and four 1/4 flat washers (Fig.
10)
ELECTRICAL CONNECTIONS
IMPORTANT: Make sure the electrical
characteristics are the same on the motor
nameplate and the power source, and make sure
the circuit on which the jointer will be used is
properly fused and that the wire size is correct.
WARNING: Electrical connections must
be made by a qualified electrician. The
machine must be properly grounded to
help avoid electrical shock and possible
death.
Consult electrical schematics, pages 38-40.
Extension Cords
Make sure your extension cord is in good
condition. When using an extension cord, be sure
to use one heavy enough to carry the current your
product will draw. An undersize cord will cause a
drop in line voltage resulting in loss of power and
overheating. The chart (Fig. 11) shows the
correct size to use depending on cord length and
voltage, which should be listed on the motor plate
of the machine. If in doubt, use the next heavier
gauge. The smaller the gauge number, the
heavier the cord.
!