© 2014-2015 Minuteman International, Inc.
Armadillo 9X Sweeper #4100033 Rev. D 07/15
Page 72
Floor Clearance and Dump Angle Adjustment
NOTE: In order to perform properly, the hopper must
maintain a distance of 3.5 in (8,9 cm) from the
floor to the rear hopper entrance lip. The front of
the hopper should be adjusted so that the front
bumper aligns with the hopper frame where the
two meet. When properly adjusted, the front
edge of the hopper will be 5 in - 6 in (12,7 cm -
15,2 cm) from the floor.
1. Park the machine on a level surface, shut off the
engine and engage the parking brake.
WARNING
Do not rely upon the hydraulic cylinders to
keep the hopper raised for maintenance.
Always engage the safety arm before
servicing the hopper.
2. Adjust the lift arm stop bolts located on top of the
wheel wells as low as possible while still allowing
the side broom assembly to clear the lift arms
when the hopper is in the NORMAL position. Be
sure that both lift arms contact the stop bolts at
the same time.
NOTE: This may involve raising and lowering the
hopper several times.
PREVENTATIVE MAINTENANCE
SAFETY
ARM
ENGAGED