Admiral 38C Scrubber PB# 4100055UM Rev.* 08/10
PowerBoss, Inc. Copyright 2010
Page 79
Maintenance and Service
5.7.5
Installing new rubber deflector
strips
The deflector (Fig. 32/1) must be
fixed in its service position (refer
to Section 2.3.1, Point 1).
Fig 32
(1) Deflector
(2) Rubber deflector strips
(3) Clamping rail
(4) Clamping rail hooks
(5) Wing nut
1. Loosen the wing nut (Fig. 32/5) at the
end of the deflector.
2. Slide the clamping rail (Fig. 32/3) in the
vehicle’s driving direction (forwards)
until the clamping rail hooks (Fig. 32/4)
are freed and the clamping rail can be
removed away from the vehicle.
3. Remove the old rubber deflector strips
(Fig. 32/2).
4. Position the new rubber deflector strips
(Fig. 32/2) in place.
5. Mount the clamping rail (Fig. 32/3)
from the outside and slide back by
hand so that the clamping rail hooks
(Fig. 32/4) engage.
6. Tighten the wing nut (Fig. 32/5) so that
it engages in the thread of the clamp-
ing rail (Fig. 32/3) and tightens the
clamping rail firmly.
5.7.6
Adjusting the rotary brush
head
If you notice that the cleaning performance
of the vehicle is no longer regular, make
a visual inspection as to whether the
rotary brush head has a greater clearance
from the ground on one side compared
to the other. If this is the case, contact an
authorized PowerBoss service center to
have the rotary brush head readjusted. A
PowerBoss service center has the tools
necessary to do this.
This work may only be completed
by an authorized PowerBoss
service center!
