
PowerBoss, Inc. Copyright 2010
Admiral 38C Scrubber PB# 4100055UM Rev.* 08/10
Page 16
Starting Up
2.3
Prior to starting up for the
first time
The following work must be completed
before starting the vehicle up for the first
time:
2.3.1
Installing the rotary brushes
Two rotary brushes must be fitted in the
rotary brush head. These rotary brushes
are not part of the scope of delivery sup-
plied with the vehicle. Choose the rotary
brushes separately according to the task
to be completed (refer to Section 4). If you
ordered the rotary brushes together with
the vehicle, the rotary brushes are nor-
mally already installed by the authorized
PowerBoss dealer prior to delivery.
Check whether rotary brushes
are fitted.
If no rotary brushes are installed, proceed
as follows to install them.
The following applies to all work
on the rotary brushes: Turn the
key switch to position 0, remove
the key and apply the parking
brake (Fig. 14/8).
The front rotary brush is changed
from the right-hand side of the
vehicle, the rear rotary brush from
the left-hand side of the vehicle.
Fig 4
(1) Deflector
(2) Deflector lock
(3) Grip
1. Open the deflector (Fig. 4/1):
take hold of the grip (Fig. 4/3), raise
the deflector (Fig. 4/1), pivot open to-
wards the front and set it down (service
position).
Fig 5
(1) Locking lever
(2) Brush holder
(3) Rotary brush
2. Slide the locking lever (Fig. 5/1) for the
brush holder (Fig. 5/2) to the middle of
the device and hold it there.
3. Allow the brush holder (Fig. 5/2) to
lower down and remove it.
4. Release the locking lever (Fig. 5/1).
5. If necessary, remove the existing rotary
brush (Fig. 5/13) from the housing
(Fig. 6/1).