PowerBoss, Inc. Copyright 2010
Admiral 38C Scrubber PB# 4100055UM Rev.* 08/10
Page 48
Operation
3.5
Function faults
The following applies when locat-
ing the cause of functional faults
and clearing them:
Switch the vehicle off, remove the
key and disconnect the battery
plug!
3.5.1
Error code table
In the case of system errors, a four-digit
error code appears in the left-hand operat-
ing panel in addition to the service indica-
tor (wrench symbol).
The dots in the error/service code flash.
Clear the fault or note down the error/
service code and inform your authorized
PowerBoss dealer.
Error code
Fault
Cause
Solution
1.2.5.2.
The brushes remain stopped be-
cause the thermostatic switch has
been tripped.
The motor has over-
heated;
foreign bodies have pos-
sibly jammed between
the brush and shaft (e.g.
tape and such).
• Check the brushes for foreign bodies
and remove them, as necessary.
• Allow the motor to cool down.
• If the problem reoccurs, determine
the cause of overheating; contact an
authorized PowerBoss service center, if
necessary.
1.2.6.1.
The brushes remain stopped
because the anti-blocking system
has been tripped.
Foreign bodies
(e.g. tape or such)
block the brushes
• Check the brushes for foreign bodies
and remove them, as necessary.
1.2.6.1.
The rotary brush holding attach-
ment and brush motors have been
switched off because the anti-
blocking system has been tripped
Foreign bodies between
the brush head and
vehicle.
• Check the brush head for foreign bod-
ies and remove them, as necessary.