Poweramp LHP Series, Инструкция для владельца и пользователя

Страница: 18 / 52

16
4111-0012 — Sept. 2018
© 2018 Systems, LLC
INSTALLATION
A— Front of Dock Pit
B— Dock Leveler Frame
C— Side Pit Curb Angle
D— Gap [3/4 in. (19 mm)
Minimum]
E— Pry Locations
F— Rear Hinge Frame
Angle
G— Rear Pit Curb Angle
H— Flare Bevel Weld, Typical
(To Fit Spacing)
8. With rear hinge frame angle ( F ) tight against rear
pit curb angle ( G ), perform/check the following:
• Pry between the platform and rear hinge frame
angle at locations ( E ) to make sure rear edge of
platform is parallel to the rear hinge frame angle
( F ).
• Gap ( D ) must exist equally along both sides of
leveler so weather seal (if equipped) will not bind
during dock leveler operation.
9. If gap ( D ) cannot be obtained equally at both
sides of leveler, grind or add material at the rear
edge of rear hinge frame angle ( F ) as needed.
10. Allow the dock leveler to rest fully on the shim
stacks. Check that a smooth and level transition
exists between the dock floor and the dock leveler
platform. Add or remove shims as necessary until a
smooth transition is obtained.
11. If leveler cannot be squared and/or made level
as instructed in steps 8-10, contact Systems, LLC
Technical Services.
Figure 11
G
H
A
B
E
C
F
C
D
6 in.
(152 mm)
3/8 in.
(9.5 mm)
D