GB
900-GB TrAnSPorTSTELLunG (20)
- 9 -
TRANSPORTPOSITION
WORKINGPOSITION
Conversion from working to transport position
Safety Precaution!
Changing from working position to transport position
is only to be carried out on even, firm ground.
• For safety reasons, turn off drive shaft and wait for rotor to stop
completely.
• Make sure that swivel area is free and that nobody is standing in
the danger area.
Hydraulic raising (Variation)
- The outer rotors are raised into the transport position by actualing
the control valve (ST).
The locking hooks engage automatically.
Attention !
- Check whether the locking hooks (10) are locked into
position correctly.
Manual raising
(standard fitting withe the HIT 47)
- Hold the tubular handle (9) with your hand and during raising
swivel the outer rotor into
the transport position.
The locking hooks engage
automatically.
Attention!
- Check whether the
locking hooks (10) are
locked into position
correctly.
- Using the tractor's lifting
gear, lower the implement far enough so that it stands on the
ground on both centre running wheels.
- Swivel the outer rotors inward to the transport position.
Swivelling the outer rotors
- Hold the tubular handle in one hand and release the bolts (position
C) with the other.
- When swivelling do not release the tubular handle until the bolts
are locked again (position G).
Conversion from transport to workingposition
Safety Precaution!
Changing from working position to transport position
is only to be carried out on even, firm ground.
Make sure that swivel area is free and that nobody
is standing in the danger area.
- Turn the rotors outward.
See "Swivelling the Outer Rotors".
- Release mechanical locks (10).
With hydraulic raising: move the control
valve (ST) briefly to the "raise" position
simultaneously pulling on the rope
(S).
Doing this releases the mechanical
locks (10).
- Lower outer rotors to the working
position.
G
C
TD 40/93/3
10
TD2/93/3
G
C
TD 40/93/2
