Potterton Gas condensing boiler, Инструкция по установке, эксплуатации и обслуживанию, Страница: 110 / 136

Manual control
(7140) Activation of manual control. If the manual control function is activated the boil-
er will be controlled to the Setpoint manual control. All pumps will be activated.
Additional request will be ignored!
Controller stop function
(7143) If the controller stop function is activated, the burner output set in the setpoint
controller stop is immediately requested by the device.
Controller stop setpoint
(7145) With activated controller stop function the output set here is requested by the
device.
Telephone customer service
(7170) Here the desired telephone number of customer service can be entered.
PStick storage pos
(7250) Via the parameter PStick Storage Pos the data set (data set number on the stick)
can be selected which should be written or read.
PStick command
(7252) - No operation : this is the base condition. As long as no operation is active on the
stick, this command is displayed.
- Reading from stick : starts reading the data from the stick. This operation is only
possible with READ sticks. The data of the set data set is copied in the LMS con-
trol. Beforehand is checked whether the data set may be brought in. If the data
set is incompatible, it may not be brought in. The display resets to no operation,
displays an error message. The text Read from stick remains until the operation
is completed or an error occurs. As soon as the data transmission begins, the
LMS control goes in a parameterization position. As soon as the parameter is
transferred, the LMS control must be unlocked after ending the transmission.
Error 183 parameterization is displayed.
- Writing on stick : Starts writing the data from the LMS control to the stick. This
operation is only possible with WRITE sticks. The data is written in the previous-
ly set data set. Before writing of the data begins, it is checked whether the data
fits on the stick and the respective customer number is correct. The text Writing
to stick remains until the operation is completed or an error occurs.
PStick progress
(7253) The read or write progress is displayed as a percentage. If no operation is active or
an error shows up, 0% is displayed.
8.25 Input/output test
Input/output tests
(7700 - 7872) Tests for checking the connected components for function.
8.26 State
State
(8000 bis 8011) With this function the state of the selected system can be requested.
Programming
110 Paramount three 30-115 kW 396532 05.11