PostProcess Technologies, Inc. • www.postprocess.com • REV A | page 9
1. Operation
The DECI is delivered with an industrial power cord. Use only the power cord supplied by
PostProcess
with the
DECI. Connect the DECI only to 3-phase 400v power 50Hz. Do not place the power cord in a location where it
could come into contact with water or other liquid substances. It is recommended to keep the entire power cord
suspended above the floor surface.
The
MASTER POWER SWITCH
is located on the left side of the DECI in the upper right corner (
Figure 1.
Location of Master Power Switch
). Before connecting or disconnecting the DECI to a power outlet, or inserting
or removing the power cord, ensure the
MASTER POWER SWITCH
is in the horizontal “O” or
OFF
position (
Figure
2. Master Power Switch “ON”
).
When the power cord is connected to the DECI and plugged into a 3-phase 400v 50Hz power outlet, turn the
POWER
switch 90 degrees clockwise to the vertical “I” or
ON
position. The DECI is now ready to be powered up.
Figure 1. Location of Master Power Switch
Figure 2. Master Power Switch “ON”
To turn off the
Master Power Switch
grab
the handle and rotate counter clockwise
90° to the OFF position.
The
Master Power Switch
is located
on the left side in the upper right corner.
The DECI utilizes 400v 50Hz power
provided through an industrial power
cable/connector located on the upper
rear of the unit as shown in
Figure 3.
Power Connector
.
Figure 3. Power Connector
1.1 Connecting Power to the DECI
