Posi-Plus Line Runner 700-40, Руководство оператора

Страница: 4 / 34

Oct-18-700 Operation Page 4 of 34
Section 1 - Unit specifications
About this manual
This manual provides instruction for the operation of the unit. The operator must be familiar
with the unit and its capabilities before using the unit on the job. This manual is written to
provide an understanding of the unit, safety, proper set-up, and operation.
General specifications
The Posi-Plus model 700 uses a telescopic boom design that is capable of movement
through 100°, from -20° below horizontal to 80° above horizontal. The turntable has a 370°
non-continuous rotation. The standard unit is manufactured with "ON/OFF" controls using
a 3-axis joystick at the platform that operates the three (3) boom functions.
If requested, an optional 3-axis proportional joystick and valve assembly is available for this
model. In this case, the proportionality obtained during simultaneous operation of the boom
functions via the platform joystick will be dependent on the maximum flow available. The
standard flow available for this model is approximately 8 GPM at 1000 engine RPM.
This unit has been designed to be operated as a mobile aerial device. The driver
must never exceed 3 km/h (2 mph) when the operator is inside the platform. It should
only be operated on firm surfaces up to 5 degrees of inclination. For a maximum
stability, the truck chassis must be on a level and firm surface only.
Height (ground to bottom of platform) 34’-1” 10,4 m
Working Height 39’-1” 11,9 m
Reach from Centerline of Rotation 29'0" 8,9 m
Stowed Travel Height 10' 5" 3,2 m
Side pull Capacity* 300 lb 136 kg
Platform Capacity* 300 lb 136 kg
Cable Down Load* 100 lb 45 kg
Lower Boom Articulation -20° to 80°
Rotation 370° non-continuous
The capacities applicable to this unit could be different and are engraved on the aerial device
identification placard on the turret (100-229-XXX).
Standard optional features

Lower remote controls

Emergency operating system (12 V dc)

Fairlead ass' y at the platform

Standardized cab control panel

Optional proportional controls are available