![Porsche 911 Turbo 2014 Скачать руководство пользователя страница 281](http://html1.mh-extra.com/html/porsche/911-turbo-2014/911-turbo-2014_owners-manual_1580146281.webp)
Minor Repairs
279
Towing a vehicle on one axle:
Raising an axle, irrespective of whether at the
front or rear, is only permissible if the drive shaft
(cardan shaft) has been removed beforehand. The
ignition must be switched off.
f
The vehicle must not be towed if the PDK
transmission is in emergency operation mode
(yellow or red “
Transm. failure Park vehicle
safely
” warning message). The vehicle must
be transported with a car transporter or on
a trailer.
f
If a selector lever emergency release was
performed, the vehicle must not be towed.
The vehicle must be transported with a car
transporter or on a trailer.
f
Move PDK selector lever to position
N
.
To properly engage selector-lever position
N
on the display and at the selector lever, the
engine must be started once before towing
the vehicle.
The vehicle can be towed as soon as the
selector lever is in position
N
and selector-
lever position
N
appears on the display.
f
Switch ignition off.
The ignition key must remain in the ignition lock
so that the steering lock does not engage.
The control unit must be removed from the
ignition lock and the key inserted in vehicles
with Porsche Entry & Drive.
f
Please see the chapter “EMERGENCY
OPERATION – UNLOCKING THE IGNITION KEY/
CONTROL UNIT” on page 28.
f
Make sure that the vehicle is adequately
illuminated.
f
Do not exceed a maximum speed of 30 mph
(50 km/h).
Maximum towing distance 30 miles (50 km).
If towing distances are greater, the vehicle
must be transported with a car transporter or
on a trailer.
Pulling out a vehicle stuck in snow,
sand, etc.
f
Always pull out the stuck vehicle with the
greatest care.
f
Do not pull out the vehicle abruptly or at an
angle.
f
If possible, pull the vehicle out backwards in
its own tracks.
PDK selector lever emergency release
In the event of an electronics failure, emergency
release of the selector lever must be performed in
order to move the selector-lever to the
N
position.
Releasing selector lever
1.
Take the plastic wedge from the toolbox.
2.
Carefully lever out the rear part of the selector
lever gate
A
on both sides (arrows) using the
plastic wedge.
3.
Carefully lever out the front part of the switch
panel
B
on both sides (arrow) using the plastic
wedge.
4.
Remove the switch module
B
and place aside.
The cable
C
of the switch panel must not be
under tension.
14_991_Turbo_21.book Seite 279 Mittwoch, 9. April 2014 2:19 14
Содержание 911 Turbo 2014
Страница 1: ...911 Turbo Owner s Manual...