▪ Supports IPv4 networks
▪ Logs all configuration change events
▪ Supports a user-based security model
▪ Supports trap destination addresses
Related Links
on page 37
Configure SNMP
You can monitor your system remotely with SNMP.
Procedure
1.
In the system web interface, go to
Servers
>
SNMP
.
2.
Configure the following settings:
Setting
Description
Enable SNMP
Enables administrators to monitor the system remotely
using SNMP.
Enable Notifications
Enables MIB notifications.
Version1
Enables your system to use the SNMPv1 protocol.
Due to security issues, Poly recommends that you don’t
enable this setting.
Version2c
Enables your system to use the SNMPv2c protocol.
Due to security issues, Poly recommends that you don’t
enable this setting.
Version3
Enables your system to use the SNMPv3 protocol.
Enabled by default, you can’t configure other SNMPv3
settings unless this is on.
Read-Only Community
Specifies the SNMP community string for your system.
For security reasons, don’t use the default community
string (
public
).
Note: Poly doesn’t support SNMP write operations
for configuring or provisioning systems. The
community string is for read operations and
outgoing SNMP traps.
Contact Name
Specifies the name of the person responsible for
remotely managing the system.
Location Name
Specifies the system location.
System Description
Provides details about the system.
Troubleshooting
89
