Polarstart PS-3085 SH, Руководство по установке

Страница: 7 / 18

7
TRANSMITTER FUNCTIONS
NOTE
: Pressing the LOCK and UNLOCK buttons simultaneously will activate the AUX 2 output. (The latter can be
programmed to give CONSTANT ground while pressed, or a 30-second timed output with remote toggle ON/OFF.)
THE PROGRAMMING ASSISTANCE BUTTON
(A.k.a. the
Hood Switch Interrupt
.) Mounted on the PS-3085 SH, this button can be used from within the vehicle instead of
the Hood Pin-Switch: when the Hood is opened, pressing the button for 4 seconds will be equivalent to pressing the Hood
Pin-Switch – it will cut the ground signal from the Hood Switch line.
Note:
The Hood Switch must be installed and connected for the Programming Assistance Button to function.
LEARNING A TRANSMITTER
The
PS-3085 SH
Transmitter does not come pre-programmed and must be code-learnt after the wiring of the Module is
complete. The system has the ability to learn up to 4 different Transmitters; if a fifth Transmitter is learnt, the first
Transmitter in memory will be lost. To erase all Transmitters from memory, you must perform a Module reset.
To program a new Transmitter, do the following:
1. Ensure that Ignition is OFF.
x
Hold the Hood Pin-Switch down for 4 seconds.
x
Release the Pin-Switch. The Parking Lights should come on.
x
With Parking Lights on, immediately push and release the Pin-Switch again. Parking Lights will stay on for up to
20 seconds.
2. Turn the Ignition Key ON (Wait until the Parking Lights go OFF), and then turn the key OFF, ON, OFF.
(NOTE: The L.E.D. should be flashing during the next step)
3. Press the LOCK button (or the UNLOCK button), wait 1 second and press the button again until the Parking Lights flash
5 times quickly.
4. To exit, close the hood.
NOTE:
x
In Programming Mode the L.E.D. follows the Parking Lights.
x
The system can hold a maximum of 4 Transmitters in memory.
x
When programming a Transmitter on a second vehicle, you must simultaneously press the LOCK and TRUNK
buttons in step 3 instead of pressing the lock button twice.
VALET OPERATION
The system can be placed in Valet Mode to disable the remote starting capabilities. This is necessary when the vehicle is
being serviced.
Get INTO Valet Mode
1. Turn on the Ignition Key .
2. Press and hold the Valet Push-Button for approx. 2 seconds. The L.E.D. will come ON.
Remote Engine shut
down (STOP).
Cold-weather timer ON
& HOME VALET
activation.
UNLOCK (DISARM
Starter Disable) or
AUX 2 (Priority Door
Access if pressed for a
second time.)
LOCK
(ARM Starter Disable)
TRUNK release or
AUX 3 (remote time-
controlled output).
Selectable 30-second
signal.
Remote Engine START.