Polarstart PS-3085 SH, Руководство по установке

Страница: 2 / 18

2
INTRODUCTION
The PS-3085 SH system is a state-of-the art remote car starter representing a breakthrough in vehicle convenience
technology. Designed with OEM integration in mind, it can be customized and used for almost every possible application. By
integrating time-latched and ON/OFF outputs, this Unit can single-handedly control virtually any electrical system in your
vehicle.
WHAT IS INCLUDED
Before beginning the installation, please review the Installation Guide – particularly the wiring diagram and the
programming options.
NOTE:
It is very important that you familiarize yourself with the programming and operation of the PS-3085 SH system,
even if you have already installed a Polarstart system in the past. There are many great new features that may be overlooked
if the manual is not read: you would therefore not maximize the potential of the PS-3085 SH.
Prior to installation, make sure that all the hardware components required to install the system are in the box.
The following is a list of components included in the kit:
x
1 - PS-3085 SH Control Unit
x
1 - Super-heterodyne Receiver
x
1 - SH interconnect cable
x
1 - Five-button multi-channel Transmitter
x
1 - Plug-in push-button Valet Switch
x
1 - Plug-in 2-volt LED
x
1 - Hood Pin-Switch
The kit should also include the following:
x 1 - 6-pin Main Ignition Harness
x
1 - 5-pin Secondary Harness
x
1 - 12-pin Accessories Harness
x
1 - 2-pin Secondary Harness
x
User Guide and Installation Guide
FCC USER NOTICE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID
THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
INSTALLATION POINTS TO REMEMBER
x
On vehicles with a manual Transmission, ALWAYS ensure that all Doors will get the Unit out of Ready Mode. Switch
the wire used so that it is triggered by all Doors.
x
Make sure that the Parking Brake and Door Switch contacts work properly.
x
Always use a Motion Detector when installing this unit on convertible vehicles.
x Always leave a window open when working on a vehicle.
x
NEVER leave the keys in the car. Leave them on a workbench!
x
If possible, remove the fuse of the courtesy light to prevent battery drain, but BEWARE of coded radios: make sure you
have the code before removing power to the car .
x
Inspect the vehicle for any body damage or electrical problem.
x
Make sure that all the switches and controls operate properly.
x
Verify whether the vehicle starts and idles properly.
x
Never install the Control Unit where it could interfere with normal operation or obstruct service technicians.
x
Do not disconnect the battery on vehicles equipped with air bags and anti-theft radios.
x
Always use a grommet when running wires into the Engine compartment; never run wires through bare or sharp metal.
x
Always solder and tape all connections.
x
Never ground the Control Unit to the Steering Column of the vehicle.
x
Keep the antenna away from other antenna types (GPS/OnStar).
x
Make sure that all safety equipment is installed: the Valet Switch, the Hood Switch and the Warning Label.