15
Horn Chirp Timing
Follow these steps to program the Horn Confirmation:
1. Make sure that the Ignition is OFF.
x
Hold the Hood Pin-Switch down for 4 seconds.
x
Release the Pin-Switch.
The Parking Lights should come on.
x
With the Parking Lights on, immediately push and release the Pin-Switch again.
The Parking Lights will stay
on for up to 20 seconds
.
2. Press and hold the Brake Pedal.
3. Press the UNLOCK and START buttons; the Horn will chirp 5 times (Only if Horn is programmed in MODE 3 –
FUNCTION 4)
4. Release the buttons of the remote control; to increase the Horn Pulse by 6 ms, press the LOCK button; to decrease
the Horn Pulse by 6 ms, press the UNLOCK button; to increase the Horn Pulse by 20 ms, press the START or STOP
button; to decrease the Horn Pulse by 20 ms, press TRUNK.
For each timing change, the Horn will chirp using the new settings, except under the following circumstances:
x
When the lower limit of 6 ms is reached, the Horn will sound for 1/4 second.
x
When the upper limit of 240 ms is reached, the Horn will sound for 3/4 second.
x
A system reset will set the system back to the 22-ms default.
5. If you press LOCK and UNLOCK, 3 chirps will be heard to indicate that the new values were saved.
Or Close the Hood to cancel the changes.
AUX 3 – TRUNK or Sunroof control
(MODE 3 – FUNCTION 2) This 500 mA negative AUX 3 output can be used for many different applications. The output can
be programmed to give a 1-sec pulse, or to give a continuous output as long as the TRUNK is held down (for Sunroof or
Window close).
NOTE: If AUX 3 is programmed for a 1-second TRUNK signal, you will need to hold the TRUNK
button down for 2 seconds in order to pop the trunk.
The following diagrams show how to use this output for Positive or Negative TRUNK release systems.
In Trunk Mode, TRUNK operates only when Ignition is OFF or when the vehicle is running under remote control.
TRUNK output with DISARM / REARM pulse
(MODE 3 – FUNCTION 2 – OPTION 3) When this option is selected, a DISARM signal will be sent before the TRUNK is
popped. An ARM signal will be sent 4 seconds later. (This option is overridden when the
Zone 3 Bypass
is programmed.)
Programmable External Trigger
(MODE 3 – FUNCTION 4)
x
When the External Trigger wire is programmed as Zone 3 Sense wire, pressing TRUNK will pulse the DISARM
signal for 1 second. If Zone 3 is detected (ground), a REARM is sent 5 seconds after Zone 3 closes. If Zone 3 is un-
changed (no ground), a REARM is sent 4 sec. after the button is pressed (DISARM is sent only if the system was
previously LOCKED and ARMED).
If Secure Lock is enabled, a LOCK pulse and a REARM pulse will be sent.
x
When the External Trigger wire is programmed as External Trigger, a ground pulse on this line will START or
STOP the car.
This can be used to set the system in Ready Mode.
x
When the External Trigger wire is programmed as Key Sense, when a key is detected (Key in Ignition – Negative
signal) the Starter Kill will not be rearmed even when it is set to Passive Mode. If Secure Lock is programmed,
LOCK and REARM won’t be activated while Key Sense is active.
Содержание PS-3085 SH
Страница 6: ...6 WIRING DIAGRAM ...
