6
AU
Telephone Helpline: 1300225960
LED
Message
• If it is on for ½ second every 3 seconds, the test to verify correct pin probe insertion
will be ongoing
• If flashing and the LED
is on, then the test to verify correct pin probe insertion will
have had a negative outcome and the cycle will have been started in timed mode
• If flashing and the LED
is on, the chilling stage will have had a negative outcome
and so this will continue
• If flashing and the LEDs
and
are on, the chilling stage will have had a negative
outcome, the device will have switched to storage mode and this will be ongoing
Storage LED
• If on, a storage operation will be ongoing
• If flashing then the operational set point will be being modified while a storage
operation is ongoing
Alarm LED
• If on, an alarm is ongoing
Degree Celsius LED
• If on the unit of measurement for temperature is degrees Celsius
Degree Fahrenheit LED
• If on the unit of measurement for temperature is degrees Fahrenheit
Decimal
Point
Minute LED
• If flashing, the unit of measurement of magnitude displayed is the minute
d
• Defrosting or drip draining is ongoing
Operational Cycles
The device has the following operational cycles:
• Timed positive chilling and storage
• Timed negative chilling and storage
• Set-temperature positive chilling and storage
• Set-temperature negative chilling and storage.
Set-temperature cycles are preceded by a test step in order to check correct
insertion of the pin probe ( “Test To Check Correct Pin Probe Insertion”)
To re-start using the same settings as the last cycle run:
• ensure that the device is in “stand-by” mode, that no procedures are running and that another cycle
has not been selected
• press
for 2 seconds. The display will show the label of the last cycle run
• press
within 60 seconds: in the case of a timed cycle, the display will show the duration of the
blast chilling step (in minutes) or in the case of a set-temperature cycle, the set target temperature
• press
or
within 15 seconds to change the value (the setting re- mains active until another
cycle is selected, when the value r1, r2, r3 or r4 is restored)
• press
within 15 seconds and the cycle will be activated
CK640-A_A5_v1_20190507.indb 6
2019/5/7 15:55
