12
AU
Telephone Helpline: 1300225960
To select a
parameter
• press
or
To modify a
parameter:
• press
• press
or
within 15 s
• press
or leave for 15 s
To exit the
procedure
• press
and
for 4 s , or leave for 60 s
Note: Interrupt the power supply after altering the parameters.
Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with water only.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• Take care when cleaning the rear of the appliance. Sharp edges can cut.
• A POLAR agent or qualified technician must carry out repairs if required.
Cleaning the condenser
• Periodically cleaning the condenser can extend the life of the appliance.
• POLAR recommend that a POLAR agent or qualified technician clean the condenser.
Cleaning the water pan
• The water pan is located underneath the evaporator at the back of the unit.
• To remove it for cleaning, simply slide out when necessary.
Alarms
Code
Message
Remedies
Consequences
AL
Minimum temperature
alarm
• Check the cabinet temperature
• Check parameters A1 and A2
The device will continue
to function normally
AH
Maximum temperature
alarm
• Check the cabinet temperature
• Check parameters A3 and A4
The device will continue
to function normally
id
Micro-port input alarm
(only in “stand-by” mode
and if parameter i0 is set
to 0 or 1)
• Check the causes which activated
the input
• Check parameters i0 and i1
The outcome set by
parameter i0
iA
Compressor protection
input alarm (only if
parameter i0 is set to 2)
• Check the causes which activated
the input
• Check parameters i0 and i1
The compressor will be
shut down
Note: When the cause that triggered the alarm has been resolved, the device restores
normal operation.
CK640-A_A5_v1_20190507.indb 12
2019/5/7 15:55