48
49
...THERE ARE IRREGULAR READINGS?
1.
Reset the heart rate monitor and clear the memory by
pressing the reset button with a pen tip.
The display becomes full of digits.
2.
Press STORE/LAP/RECOVERY to enter the Time mode.
3.
Start the settings from beginning.
Resetting clears totally all data from the memory and enters
the default settings.
...THE SPEED READING IS 00 OR THERE IS NO SPEED READING IN THE
DISPLAY DURING THE RIDE?
1.
If the 00 readings appear only occasionally, they may be
caused by high voltage power lines in your surroundings.
2.
If the 00 readings come more often, you propably have ridden more than
2500 hours, and it's time for battery replacement.
(For instructions, see page 56)
3.
If you just have
started the measure-
ment, you should wait
until the code search
is finished and then
start riding the bike
to get the speed
signal successfully.
4.
In any case, check
the positioning of the
Polar Speed Sensor
from the illustrations.
Check also that the
distance between the
Polar Speed Sensor
and the bike mounted
Receiver should be
between 40-50 cm /
1'4"-1'8".
5.
Check that the spoke
magnet is installed
correctly and the
distance between the
spoke magnet and the
sensor is not more
than 5 mm / 0.2".
Adjust the spoke
magnet by rotating it
around the spoke
before putting the
metal cover on the
magnet.
See illustrations.
FREQUENTLY ASKED
QUESTIONS
FREQUENTLY ASKED
QUESTIONS
WHAT SHOULD I DO IF...
...I DON’T KNOW WHERE I AM IN THE SETTING CYCLE?
Press SELECT several times until you are back in the Time mode.
...THERE IS NO HEART RATE READING?
1.
Check that the elastic strap is tight enough.
2.
Check that the electrodes of the Transmitter are moistened
and that you are wearing it as instructed.
3.
Check that you have kept the Transmitter clean.
See
Care and maintenance
.
... THE HEART SYMBOL FLASHES IRREGULARLY?
1.
Check that your Wrist Receiver is inside the transmission range and not
further than 1 meter / 3 feet from Transmitter you are wearing.
2.
Check that the elastic strap has not become loose during exercise.
3.
Make sure that the electrodes are moistened.
...OTHER PERSON WITH HEART RATE MONITOR OR EXERCISE
EQUIPMENT IS CAUSING INTERFERENCE?
Make sure there are no disturbances such as high voltage power lines,
televisions, cars, cyclocomputers, exercise equipments or other people with
heart rate monitors near you during the code search. The benefit of the
coding is that you will not normally pick up other people’s heart rate
transmission and certain kinds of disturbances are more efficiently filtered.
However your training partner may have coincidentally activated exactly the
same code. In this case you have the following alternatives:
1.
Keep distance to your training partner and continue your training session
normally
or
2.
Stop the heart rate measurement (see Stop the heart rate measurement),
pull the transmitter off your chest for 15 seconds (code will be changed)
and restart from the beginning (see Starting the measurement).
In some cases you may need to dry the transmitter electrodes to ensure that
the transmitter is turned off and on again, as the sweat may keep it active
even when it is off the chest.
A VIEW FROM
THE FRONT
90
°
SPEED
SENSOR
A VIEW FROM
THE TOP
90
°
1. ROTATE
SPOKE
2. PULL THE
METAL COVER ON
Содержание Xtrainer Plus
Страница 36: ...65...
