56 57
TECHNICAL SPECIFICATIONS
TECHNICAL SPECIFICATIONS
Polar Heart Rate Monitor is designed to indicate the level of
physiological strain and intensity in sports and exercise. No other
use is intended or implied. Heart rate is displayed as number of
heart beats per minute (bpm).
POLAR CODED TRANSMITTER
Battery type: Built-in Lithium Cell
Battery life: Average 2500 hours of use
Operating temperature: -10 to +50
O
C / 14 to 122
O
F
WRIST RECEIVER
Display: Liquid crystal display. Total 160
segments
Case: 48 x 42 x 11 mm
Operating temperature: -10
o
C to +50
o
C / 14 to 122
o
F
Battery type: CR 2032
Battery life: Average 1 year (1h/day, 7 days/week)
Water resistance: to 20 metres
Accuracy of heart rate
±
1% or
±
1 beats per minute,
measurement: whichever larger, definition applies
to steady state conditions
POLAR SPEED SENSOR
Battery type: CR 2032
Battery life: Average 2500 hours of use
DEFAULT SETTINGS:
Timer 1: 0:00 0 (off)
Timer 2: 0:00 0 (off)
Timer 3: 0:00 0 (off)
Upper heart rate limit 1: 160
Lower heart rate limit 1: 80
Upper heart rate limit 2: 0
Lower heart rate limit 2: 0
Upper heart rate limit 3: 0
Lower heart rate limit 3: 0
Recovery function: off
Primary Time Display: Chrono
Secondary Time Display: Time of Day
Recording interval: 5 seconds
Wheelsize 1: 2000
Wheelsize 2: 2100
CARE AND MAINTENANCE
CARE AND MAINTENANCE
1. Keep the Wrist Receiver and Transmitter clean. Wipe off any
moisture before storing.
2. Wash the Transmitter regularly after use with a mild soap and
water solution.
3. Dry the Transmitter carefully after washing.
4. Store your heart rate monitor in a breathable material when not
in use, not in a gym bag or plastic bag.
5. Both the Wrist Receiver and the Polar Transmitter are water
resistant but do not press the Receiver buttons under water.
6. Do not stretch or bend the Transmitter. This may damage the
electrodes.
WRIST RECEIVER
The estimated average battery life of the Wrist Receiver is
1 year
in normal
use (1h/day, 7 days a week). To ensure the water resistance properties, the
Wrist Receiver Battery should be replaced only by a person authorised by
Polar Electro Oy. See
Service
.
POLAR CODED TRANSMITTER
The estimated average battery life of the Polar Coded Transmitter is
2500
hours of use
. Contact your distributor/dealer for a replacement Transmitter.
NOTE: Polar recycles used Transmitters.
POLAR SPEED SENSOR
The estimated average battery life of the Polar Speed Sensor is 2500 hours
of use. To change the battery, we highly recommend you send it to
authorised Polar Service for battery replacement, where the unit is
waterproof tested after the replacement. However, if you prefer changing the
battery yourself, please follow these instructions carefully:
1.
Loosen the tightening screw to detach the sensor from the mounting
bracket.
2.
Unscrew the four small screws of the sensor.
3.
Open the case. Make sure that the rubber gasket stays in it’s place.
4.
Remove the battery carefully with a pen tip. Put in a new battery with the
plus (+) side facing down. (Battery type CR 2032, available at any
electronics store near you.)
5.
Close the case.
6.
Replace the four screws.
7.
Test the sensor by checking that it gives out a red flash every time the
spoke magnet passes the speed sensor.
8.
Do not throw the replaced battery away with normal waste, take it to a
place where problem waste is handled.
Содержание Xtrainer Plus
Страница 36: ...65...
