28
29
STARTING THE
MEASUREMENT
2.
Press STORE/LAP/RECOVERY to lock your selection.
The second digit starts to flash.
3.
Press SIGNAL/LIGHT to set the second digit.
4.
Press STORE/LAP/RECOVERY to lock your selection.
The third digit starts to flash.
5.
Press SIGNAL/LIGHT to set the third digit.
6.
Press STORE/LAP/RECOVERY to lock your selection.
The fourth digit starts to flash.
7.
Press SIGNAL/LIGHT to set the fourth digit.
8.
Press STORE/LAP/RECOVERY to lock your selection.
The fifth digit starts to flash.
9.
Press SIGNAL/LIGHT to set the fifth digit.
10. Press STORE/LAP/RECOVERY to lock your selection.
The last digit starts to flash.
11. Press SIGNAL/LIGHT to set the last digit.
You have the following two alternatives to continue:
1. To continue with setting the Heart rate mode, press
simultaneously SET/START/STOP and SIGNAL/LIGHT.
2. To return to Time mode, press SELECT twice.
Your Time mode looks like this if your most
recent exercise was done in
Cycling mode
.
In this case the following starting procedure
starts the
Cycling mode
. The Heart rate
mode is started in Time mode by pressing
simultaneously SET/START/STOP and SIGNAL/
LIGHT.
Cycling mode indicator
Your Time mode looks like this if your most recent
exercise was done in
Heart rate mode
.
In this case the following starting procedure
starts the
Heart rate mode
. The Cycling
mode is started in Time mode by pressing
simultaneously SET/START/STOP and SIGNAL/
LIGHT.
1. Wear the Transmitter and Receiver as described
in
Getting going
.
2. Check that there are no disturbances near you as you are about
to start the code search for coded transmission.
Make sure that the code search will be successful:
•
Keep the bike still. Do not ride it yet.
•
Keep the Receiver within 1 meter from your Polar Coded
Transmitter, which you are wearing.
•
Check that you are not near to other people with heart
rate monitors, high voltage power lines, televisions, cars,
exercise equipment etc.
STARTING THE
MEASUREMENT
Содержание Xtrainer Plus
Страница 36: ...65...
