Plymovent Shield 5k1, Инструкция по установке и эксплуатации

Страница: 10 / 32

0507347110/160114/B SHIELD fire safety solutions (5k1) | INSTALLATION | EN - 9
6.1 Product description and operation
Set of two temperature detectors to be installed in the filter
housing. When measuring a temperature of 88°C (190°F) or
more, they give a signal to the connected fire detection panel
ShieldControl to activate the fire suppression system.
6.2 Installation
Location:
Fig. 6.1
- 1st heat sensor: on top of filter housing (A)
- 2nd heat sensor: in hopper just above dustbin (B)
- 1 heat detector set per filter module (# hoppers = # heat
detector sets)
Fig. 6.1
Fig. 6.2
•
Mount the heat sensors in the filter housing(s) + hopper(s);
A = housing
B = hopper.
Fig. 6.2
6.3 Electrical connection -Zone 2-
To be sourced locally:
- connection wire: 5 x 20 AWG shielded cable
Wiring
One or more sets of temperature detectors must be wired in
parallel. The detectors act as one sensor and are connected to
Zone 2 (ref. electrical diagram on page 29).
End of line resistor (REOL)
The last detector that is wired to the fire detection panel
ShieldControl must be fitted with an EOL resistor according to
Fig. 6.3. The EOL resistor of the heat detector is supplied with
the fire detection panel and can be found in Zone 2 of the
relevant terminal.
• Take the EOL resistor from Zone 2 of the ShieldControl panel
and place it in the last heat detector according to Fig. 6.3.
Fig. 6.4 shows the first heat sensor without EOL resistor.
Fig. 6.3: Heat sensor with EOL resistor (REOL)
6 HEAT DETECTOR SET
Scope of supply:
- heat detector (2) with
junction box (2)
- cable gland M25 (2)
- nut cable gland M25 (2)
- cable gland M16 (4)
Refer to the available application data sheet about
SHIELD fire safety solutions for the required number
of heat detector sets per filter type.
A
C
A
B
B
A