Plymovent DRAFTMAX BASIC, Инструкция по установке и эксплуатации

Страница: 8 / 21

0507060400/010920/M DraftMax Basic | DraftMax Ultra 7
Fig. 4.5
A
B
Mounting of the back panel
4.4.2 Backdraft kit
□ Backdraft panel
□ Narrowing plate (2)
If you have side panels as well, we recommend to
install them to the backdraft panel first. Refer to
paragraph 4.4.3.
ATTENTION!
When the downdraft table is used for grinding only,
we recommend not to mount the narrowing plates
in the backdraft panel. For welding and plasma
cutting, however, the narrowing plates are
required .
To install the backdraft kit, do the following.
Fig. 4.6
• Remove the cover strip. Keep the 8 bolts.
• Put the narrowing plates (B) on the downdraft table.
• Put the backdraft panel (A) in place.
• Attach the narrowing plates and the back panel with the 8
bolts.
The cover strip becomes redundant.
Fig. 4.6
A
B
Mounting of the backdraft kit
4.4.3 Side panels
□ Left side panel
□ Right side panel
To install the side panels, do the following.
Fig. 4.7
• Loosen the bolts on the loose side of the hinges and
remove the washers. Keep the bolts and washers.
• Put the pins through the holes on the sides of the back
panel or backdraft panel.
• Put the washers and bolts over the pins.
• Tighten the bolts.
Fig. 4.7 Mounting of the side panels
4.4.4 Cover strip
To install the cover strip, do the following.
• Remove the cover strip. Keep the 8 bolts.
• Put the cover strip onto the downdraft table.
• Attach it with the 8 bolts.
4.4.5 Plasma cutting work grid
□ Grid frame (2)
□ Metal bar (2x13)
□ Additional perforated steel spark arrester (2)
To install the plasma cutting work grid, do the following.
Fig. 4.8
• Put the perforated steel spark arresters (A) over the pre
spark arresters. Make sure to direct the edgeless sides to
the back.
WARNING!
Do not remove the standard spark arresters.
Fig. 4.8
A
Mounting of the perforated steel spark arresters
Fig. 4.9
• Remove the ground bracket at the position of the work
grid. Keep the bolts.