Plymovent DRAFTMAX BASIC, Инструкция по установке и эксплуатации

Страница: 10 / 21

0507060400/010920/M DraftMax Basic | DraftMax Ultra 9
Fig. 4.13
C (x2)
D (x2)
Mounting of the HEPA box
If you will install a Silencer/Outlet duct, the outlet
panel of the HEPA box is redundant.
When the downdraft table is at its final position:
• use the adjusting feet to put the table in fully horizontal
position
The outlet panel of the downdraft table becomes redundant
anyway.
4.4.7 Silencer/Outlet duct
□ Upper shaft with top grid
□ Lower shaft
□ Draught strip
□ Bolt (6)
□ Washer (6)
You can connect the Silencer/Outlet duct to the HEPA box or
install it directly to the downdraft table.
To install the Silencer/Outlet duct, do the following.
Fig. 4.14
• If applicable: remove the outlet panel of the downdraft
table or the outlet panel of the HEPA box. Keep the 4 bolts.
• Apply the draught strip to the downdraft table (A) or HEPA
box (B).
Fig. 4.14
B
A
Draught strip
Fig. 4.15
• Put a bolt (C) halfway through the 2 lower holes at the
outlet of the downdraft table or HEPA box.
Fig. 4.15
C (x2)
Fig. 4.16
• Put the lower shaft (B) of the Silencer/Outlet duct over the
bolts (C).
• Move it in an upright position and put a bolt (A) in the 2
upper holes.
• Tighten the 4 bolts.
Fig. 4.16
B
C
A
Mounting of the lower shaft
Fig. 4.17
• Put the upper shaft (A) on top of the lower shaft (B).
• Attach it with the 6 bolts + washers (C).
Fig. 4.17
A
C (6x)
B
Mounting of the upper shaft
The outlet panel of the downdraft table becomes redundant.