Plymovent DRAFTMAX BASIC, Инструкция по установке и эксплуатации

Страница: 9 / 21

0507060400/010920/M DraftMax Basic | DraftMax Ultra 8
• Install the grid frames.
• Attach the grid frames with the 2 bolts (B).
WARNING!
It is necessary to apply the bolts to earth the work
grids.
Fig. 4.9
B
Mounting of the grid frames
Fig. 4.10
• Install the metal bars (C).
The standard work grid and the ground bracket become
redundant.
Fig. 4.10
C (x26)
Mounting of the metal bars
4.4.6 HEPA kit
□ HEPA box with filter
□ Adjusting foot (2)
□ Spare bolts M6 (4)
□ Draught strip
ATTENTION!
To avoid damage, handle the HEPA box and filter
with care when you unpack and install it.
To install the HEPA kit, do the following.
Fig. 4.11
• Remove the outlet panel of the downdraft table. Keep the 4
bolts.
• Apply the draught strip (A) to the downdraft table.
Fig. 4.11
A
Draught strip
Fig. 4.12
• Push a screwdriver or other tool at the position of the strips
(B) to unlock the HEPA filter.
• Remove the HEPA filter.
• Install the adjusting feet under the HEPA box.
Fig. 4.12
B (2x)
Remove the HEPA filter
To make it easier to install the HEPA box:
• remove the outlet panel of the HEPA box
• remove the outlet grid inside the downdraft table
Do not forget to install them again.
Fig. 4.13
• Put a square bolt halfway through the 2 upper holes (C) at
the outlet of the downdraft table.
• Hang the HEPA box on the bolts.
• Put a bolt through the 2 lower holes (D) in the HEPA box.
• Tighten the 4 bolts (C+D).
•
Put the HEPA filter in the box.
• Pull the two straps tightly to lock the filter. When you hear
a click sound the filter is correctly locked.