CIP Training
Plockmatic LCT3500 Large Capacity Tray
Troubleshooting - Fault codes
Fault Codes
LCT-301 Jam Tray A (LSM)
Jam is a paper flow error detection. Jam checks if a sheet is moved past the DSD sensor
correctly. Time is measured from when the DSD sensor sees the leading paper edge until the
DSD sensor sees the trailing edge of the paper. A Jam condition is generated if this
measured time is too long.
Actions:
•
Ensure that DSD sensors Q501/502 is clean and calibrated properly (see sensor cali-
bration procedure in this section of the manual)
•
Check that there are no obstructions in the paper path
•
Turn off DSD sensor from the Settings page
LCT-302 Too Long ,Tray A (LSM)
Too Long is a paper length error detection. Too long checks if a sheet is too long when it
passes the DSD sensors Q501/502. Time is measured from when the DSD sensor sees the
leading paper edge until the DSD sensor sees the trailing edge of the paper. A Too Long
condition is generated if the measured time is too long, but not long enough to gen-erate
a Jam. The sheet will be held in subsequent unit.
Actions:
•
Open subsequent unit and remove sheet.
•
See Misfeed Tray A (LSM) Actions.
LCT-303 Too Short, Tray A (LSM)
Too Short is a paper length error detection. Too Short checks if a sheet is too short when it
passes the DSD sensors Q501/502. Time is measured from the situation when the DSD sensor
sees the leading paper edge until the DSD sensor sees the trailing edge of the paper. A Too
Short condition is generated if the measured time is too short. The sheet will be held in
subsequent unit.
Actions:
•
Open subsequent unit and remove sheet.
•
See Misfeed Tray A (LSM) Actions.
LCT-304 Too Thick, Tray A (LSM)
Too Thick is a paper thickness error detection. Too Thick checks if a sheet is too thick when
it passes the optical DSD sensor Q501. When the optical DSD sensor sees the leading paper
edge, thickness is measured. A Too Thick condition is generated if the measured thickness
on a sheet is too thick compared to the calibration sheet. The sheet will be held in
subsequent unit.
Actions:
•
Open subsequent unit and remove sheet.
•
See Misfeed Tray A (LSM) Actions.
NOTE:
For components locations, refer to the
Guide to Components
section.
NOTE:
For components locations, refer to the
Guide to Components
section.
