CIP Training
Plockmatic LCT3500 Large Capacity Tray
Troubleshooting - Fault codes
Fault Codes
LCT-100/200 Misfeed Tray 3/4
Misfeed is a paper flow error detection. Misfeed checks if a sheet is moved correctly from
paper pile to optical DSD sensor. Time is measured from the start of the drive roller (used to
feed and separate a sheet from the paper pile) until the optical DSD sensor can see the
leading paper edge. A Misfeed condition is generated if this measured time is too long.
Actions:
•
Ensure that DSD sensor Q101/201 is clean and calibrated properly (see sensor calibra-tion
procedure in this section of the manual)
•
Check that there are no obstructions in the paper path
•
Turn off Optical DSD sensor from the Settings page
LCT-101/201 Jam Tray 3/4
Jam is a paper flow error detection. Jam checks if a sheet is moved past the optical DSD
sensor correctly. Time is measured from when the optical DSD sensor sees the leading paper
edge until the optical DSD sensor sees the trailing paper edge. A Jam condition is generated
if this measured time is too long.
Actions:
•
Ensure that DSD sensor Q101/201 is clean and calibrated properly (see sensor calibra-tion
procedure in this section of the manual)
•
Check that there are no obstructions in the paper path
•
Turn off Optical DSD sensor from the Settings page
LCT-102/202 Too Long, Tray 3/4
Too Long is a paper length error detection. Too long checks if a sheet is too long when it
passes the optical DSD sensor Q101/201. Time is measured from when the optical DSD
sensor sees the leading paper edge until the optical DSD sensor sees the trailing paper
edge. A Too Long condition is generated if the measured time is too long, but not long
enough to generate a Jam. The sheet will be held in subsequent unit.
Actions:
•
Open subsequent unit and remove sheet.
•
See Misfeed Tray 3/4 Actions.
LCT-103/203 Too Short, Tray 3/4
Too Short is a paper length error detection. Too Short checks if a sheet is too short when it
passes the optical DSD sensor Q101/201. Time is measured from the situation when the
optical DSD sensor sees the leading paper edge until the optical DSD sensor sees the trailing
paper edge. A Too Short condition is generated if the measured time is too short. The sheet
will be held in subsequent unit.
Actions:
• Open subsequent unit and remove sheet.
• See Misfeed Tray 3/4 Actions.
NOTE:
For components locations, refer to the
Guide to Components
section.
NOTE:
For components locations, refer to the Guide to Components
s
ection.
