CIP Training
Plockmatic LCT3500 Large Capacity Tray
Setting Up a Job
Testing the changes
Before starting a job, Plockmatic recommends testing the changes made in manual mode
with the “test settings” button under the Tools Menu (see section 3 of this manual).
This function activates all the fans and moves the elevator to process position according to
your settings. The sheets will continue to float until the test mode is stopped.
As a rule of thumb, there should be from 10 to 20 sheets floating over the stack of unseparated
paper.
fig.
fig.
fig.
If the LCT is set correctly, the sheets will
be floating horizontally with equal amounts
of separation between sheets as shown in
figure 1.
If sheets are floating with the leading edge
pointing up, the process position value should
be increased while the separation air value
should be decreased, in order to get the paper
floating as in figure 1.
If sheets are floating with the leading edge
pointing down, the process position value
should be decreased while the separation air
value should be increased, in order to get the
paper floating as in figure 1.
Stack of unseparated paper
Stack of unseparated paper
Stack of unseparated paper
Select the green checkmark button to
save changes. Switching to another
menu without selecting this button first
will discard all unsaved changes.
Saving changes
