Plextor PX-750A, Инструкция по установке и эксплуатации

Страница: 73 / 112

Section 5. Maintenance and Troubleshooting
PX-750 Installation and Users Manual
63
If the PX-750A drive isn’t recognized in Windows:
1. If the PX-750A drive is not recognized in Windows, reboot the
computer and use your computer’s setup program to program the
BIOS to recognize it.
NOTE: Refer to the computer’s documentation for information on how
to run the motherboard BIOS setup program.
For the PX-750A, use the motherboard BIOS setup program to set
up IDE Master and Slave designations, as needed for your
configuration, on the primary or secondary IDE bus. If the IDE
interface is disabled on your computer, you will need to enable it. If
a Master or Slave device is set to “disable” or “none” or a similar
designation, change it as appropriate to “enable” or “auto” (or
something similar, depending on your setup program).
2. Save and exit your CMOS setup to restart your computer with the
new settings.
3. In Windows 2000 or XP, right-click on the My Computer icon and
select Properties. Click on the Hardware tab, then click on the
Device Manager button. Click the + sign next to the DVD/CD-ROM
drives heading and look for the “PLEXTOR DVDR PX-750A” entry
underneath.
If you do not see this drive listed as one of the devices, or if it has a
yellow diamond with an exclamation point (!), contact Plextor Technical
Support. (See “Appendix B: Technical Support” for the different ways
you can contact us.)